Kern-sohn FC 10 Manual de usuario descargar pdf (Pagina 15)

FC-BA-e-1410 15

❸Enter Calibration interface, as shown in Fig 5-1.

Calibration interface is shown in

Fig 5-2

❹ Load a standard force. Now the value in standard input area is just equal to the

current measured value. Wait a moment for the force stabilization.

❺ Press and to input the standard force value.

❻ Press to enter the next calibration. Pressing can interrupt the calibration.

When the 3 times calibration had been finished or been interrupted, a confirm win-

dow will pop up for asking you "Save and Exit" (YES) or “Save and Exit” (NO), (Fig 5-

3a)

Press or to select, then press .

If "YES" is selected, "Calibrate complete!" is displayed, see 5-3(b).

5.4 Troubleshooting

If the force gauge in use processes such as errors, please accord to the following

way for troubleshooting, see table 5-3. Do not disassemble the gauge by yourself to

repair. If you cannot resolve the fault yourself, please contact our company.

5-3(a) 5-3(b)

Fig. 5-3

(a) (b)

❶Calibration times

❷Current measuring value

❸Standard value input

Fig 5-2

1 2 ... 10 11 12 13 14 15 16 17 18 19

Sin comentarios

Kern-sohn FC 10 Manual de usuario Pagina 15