KERN & Sohn GmbH Ziegelei 1 D-72336 Balingen E-Mail: [email protected] Tel: +49-[0]7433- 9933-0 Fax: +49-[0]7433-9933-149 Internet: www.kern-soh
ECB-BA-e-1114 10 6 Operation 6.1 Weighing • The balance is switched on by pressing the "ON/OFF" key. • The balance performs auto-dia
ECB-BA-e-1114 116.3 Rear illuminated display To choose the backlight mode, please follow the below instruction for the setting: Ö When the balance
ECB-BA-e-1114 12 6.4 Dosage und Zero-tracking When the Auto-Zero-function is activated, any slight changes of the zero readout are automatically tar
ECB-BA-e-1114 136.5 AUTO-OFF function For battery operation the balance has an automatic switch off function which can be activated and deactivated i
ECB-BA-e-1114 14 6.6 Reset function Factory setting reset. Ö When the balance is switched off, press the TARE -key and keep it pressed Ö Do not re
ECB-BA-e-1114 157 Maintenance, upkeep, disposal 7.1 Cleaning Please disconnect the device from the operating voltage before cleaning. Only use a
ECB-BA-e-1114 16 8 Troubleshooting The balance should be switched off for a short time following an interruption in the programme sequence and dis
ECB-BA-e-1114 2 GB KERN ECB Version 1.4 08/2011 Operating instruction Platform scale Tabel of contents: 1 Technical data...
ECB-BA-e-1114 31 Technical data KERN ECB10K5 ECB20K10 ECB50K20 Readout (d) 5 g 10 g 20 g Weighing range (max) 10 kg 20 kg 50 kg Taring rang
ECB-BA-e-1114 4 2 Fundamental information (general) 2.1 Intended use The balance you have acquired serves to determine the weighing value of the
ECB-BA-e-1114 52.4 Monitoring the test substances The metrology features of the balance and any possible available adjusting weight must be checked
ECB-BA-e-1114 6 5 Unpacking, installation and commissioning 5.1 Place of installation, place of use The balance is constructed in such a way that
ECB-BA-e-1114 7 5.2.2 Package volume Serial fittings: KERN ECB • Balance • Operating manual • Power adaptor 5.3 Mains supply/ Battery operati
ECB-BA-e-1114 8 Rechargeable Battery Installation: 1. Remove battery cover 2. Slide spacer to left or right, lever down on corner, t
5.4 Initial start-up A warm-up time of 5 minutes stabilises the measured values after switching on. The accuracy of the balance depends on the loca
Comentarios a estos manuales